1.打開篩網架及篩網。Open the screen frame and screen
1)松開篩網架固定用的2個把手螺母D。
Loosen the 2 handle nuts“D"used to fix the screen frame.
集中粉碎機centralized granulator
2)用手扶住篩網架往下到適當高度后往前拉出。
Hold the screen frame down to the appropriate height and pull it out.
3)將篩網從篩網架上取出。
Remove the screen from the screen frame.
2.安裝回機器部件Re-install the machine parts
2. 1)裝回篩網架及篩網
Re-install the screen and screen frame
1)將篩網放在篩網架上,對準篩網兩端的定位槽與篩網架上的止位筋。
Put the screen on the screen frame, both ends of the screen should be directed at the positioning rib between the positioning groove and screen frame.
2)移動篩網架后部的掛鉤進入切削室后部的定位槽中。
Move the hook on the back of the screen frame to the positioning groove in the cutting chamber.
3)旋轉篩網架沿上,直到與切削室完全靠住。
Rotate the screen frame upwards until it completely leans against the cutting chamber.
4)擰緊把手螺母D。
Screw down the star-shaped handle D.
5)將料倉裝回到篩網架底部的槽中。
Place the feed bin into the groove on the bottom of the screen frame.
6)篩網架部分完全裝好。
Screen frame is completely installed.
2.2)裝回上箱 Re-install the charging barrel
1)朝前扶住上箱直到與切削室閉合。
Hold the charging barrel forward until it completely fits the cutting chamber.
注:請用手扶住上箱直到閉合,防止自由跌落造成損壞。
Note: Use hands to hold the charging barrel until it completely closed to avoid damage caused by free drop.
2.3)裝回外殼 Re-install case
1)如果機器帶外殼裝置。
If the machine has case.
2)將外殼對準料筒邊沿往里推進。
Pull the case inward along the edge of the charging barrel.
3)直到插銷進入插孔內
Until the bolt enters into the jack
4)外殼安裝到位。
Case installation completed.